| GP9 is a low cost FRID Data Read/Write Engine
or so-Called Transaction Reader Module Which is featuring data encryption
and small dimensions that has been designed specifically for OEM
application. It operates at voltages as 5Volts making it ideally suited to a
wide variety of medium/high security applications .GP9 read ID code form the
transponder and read/write data to the transponder . |
- Frequency:125KHz ,ASK
- Format:64bits ,Manchester coding
- Interface: RS-232
- 9600 baud , no parity , 8 data bits , 1stop bit
- Tag:GiTAG2 (the only suitable tag for GP9)
- chip type :GI 8693 Read /Write
- ID code :10 digits in Hex ,preprogrammed and fixed
- Data:10digits in Hex ,rewriteable
- 125KHz,ASK
- 64bits ,Manchester coding
- Rate timing :MOD64 (64clocks per bit)
- Compatibility :EM H4002 (For ID code after
programmed)
- Coding :Factory preprogrammed for ID code
- Passive ,no battery required
- Operation temperature:-45 to 70 Deg. C
- Storage temperature :-45 to 70 Deg. C
- Available Size:
ISO card :8.57*5.40 *0.08 cm
Badge:8.57*5.40*0.19 cm
Round disc tags and key tag are available
- ID number :10 digits in Hex or 13 digits in Decimal
- Operating temperature :0~50 Deg. C
- Storage temperature :-10~55 Deg. C
- Humidity: 10~90 % relative
- Dimensions :W41*L24*H10 MM
- Power requirement :5~13.5 Volts regulated DC,59 mA
typical with a 12 V supply .A linear regulator is needed.
|
- Small outline ,good for OEM applications
- Wide voltage range from 5V to 13.VDC
- Potted for environmental protection
- Plug-in fitting
- High level of data encryption
- Encryption and decryption is carried out within the
small packaged engine
- Read ID code and read/write data
- 125KHz ,ASK, 64bit
- RS-232 interface ,9600,N,8,1
- Read preprogrammed ID code ,10 digits in Hex
- Read/write data ,10 digits in Hex
|
